Amada ML-2350A-CE, Operation Manual, Page: 54 / 235

54
ML-2350A/2351A
5. Connecting the Laser Controller Circuit Cable
5. Connecting the Laser Controller Circuit Cable
For separating the laser controller from the main unit for use, connect the circuit cable.
CAUTION
Be sure to turn OFF the power supply before starting a circuit cable connecting
operation.
Item required
Circuit cable, cable clamp, set screws, and Phillips screwdriver
Operating Procedure
(1) Remove the set screws for control panel on both sides and open the control
panel. Then, take out the circuit cable, cable clamp, and set screws that are
accommodated in the control panel.
(2) Close the control panel and tighten the fix screws to fix the control panel as it
was.
(3) Remove the set screws for laser controller and slide the laser controller forward
to remove it.
Main unit
Control panel
Control panel fixing screw
Circuit cable
Clamp screw
Cable clamp
Laser controller fixing screw
Control panel fixing screws Pull toward you
Items accommodated in the control panel