Amada ML-2350A-CE, Operation Manual, Page: 18 / 235

18
ML-2350A/2351A
Sticking Warning/Danger Labels
MATCH THE KEY TO THE GROOVE, INSERT AND
TURN CLOCKWISE BY HAND TO SECURE THE FIBER OPTIC.
DO NOT USE TOOL WHEN THE OPTICAL FIBERS CONNECT
TO LASER BEAM INPUT UNIT.
ご注意
を溝に合わせて差し込んで手で確実にネジを
締めて下さい。（工具は使用しないで下さい）
KEY GROOVE
ツメ ﾐｿﾞ
P-00475-001
レーザ装置本体へのファイバー接続は” ツメ ”
危
いでください。
ままレーザ発振させな
絶対にカバーを外した
失明、やけどをする LASER RADIATION
HAZARD WHEN THE
LASER BEAM MAY CAUSE
BURNS AND EYE DAMAGE.
おそれがありますので
P-00474-001
険
COVER IS REMOVED.
DANGER
熱交換器内、ポンプ内、電磁弁内、配管内の水を完全に抜き取ってください。
０℃以下になる場合は、取扱説明書をご覧になり、レーザーキャビティ内、
の環境にならないようご注意ください。
れがあります。特に寒冷地におきましては、凍結しやすいため、０℃以下
気温が０℃以下になりますと、冷却用の水が凍結し、装置が破損するおそ
注 意
CAUTION
COOLING WATER WILL FREEZE AND EQUIPMENT MAY BE BROKEN BELOW 0℃.
PARTICULARY IN COLD DISTRICTS, TAKE CARETHAT THE TEMPERATURE OF
THE EQUIPMENT DOES NOT FALL BELOW 0℃.
WHEN AMBIENT TEMPERATURE WILL FALL BELOW 0℃. SEE OPERATIONMANUAL
VALVE AND PIPING.
AND DRAIN WATER FROM LASER CAVITY, HEAT EXCHANGER, PUMP, SOLENOID
P-1487
P-00374-001
HIGH VOLTAGE
EXPOSED TO ELECTRICAL SHOCK HAZARD
IF INTERLOCK IS DEFEATED PERSONNEL MAY BE
DISCONNECT POWER AND WAIT 5MIN.
BEFORE SERVICING
感電するおそれがあります。
高圧危険
また、電源切替後５分以内は
セーフティインタロックを解除すると
内部に絶対に触れないでください。
LB1165499
HIGH VOLTAGE
高圧危険
P-1373
DANGER
REPLACE WITH THE FUSE WITH
EQUAL OR LOWER RATING ONLY.
AVOID EXPOSURE
IS SCATTERED FROM THIS APERTURE
INVISIBLE LASER RADIATION
LB1165499
不可視ﾚｰｻﾞ光が散乱します。
不可視レーザ光
注意－ここから
P-1388
HIGH
VOLTAGE
IF INTERLOCK IS DEFEATED
PERSONNEL MAY BE EXPOSED
TO ELECTRICAL SHOCK HAZARD.
P-1534
注 意
精製水をタンクに入れた後に付属の落とし蓋を
水面に浮かべてから使用してください。
詳細は取扱説明書をお読みください。
CAUTION
AFTER FILLING WITH DI WATER, FLOAT THE ATTACHED
FLOATING PANEL ON THE WATER.
PLEASE REFER TO THE USER'S MANUAL FOR DETAILS.
P-1517
Inside of the top surface of the main unit
(top surface of the frame)
Inside of the top surface of the main unit
(top surface of the frame)
Inside of the top surface of the main unit
(top surface of the acrylic chamber in the
branch unit)
Inside of the main unit
(top surface of the trigger unit in the branch unit)
(under the interlock board)
(side surface of the board cover of the balance board)
(side surface of the simmer unit)
(side surface of the capacitor unit)
(side surface of the high voltage cover of the charge
unit)
(side surface of the discharge unit)
Inside of the top surface of the main unit
(top surface of the branch unit cover)
Inside of the top surface of the main unit
(top surface of the branch unit cover)
Inside of the front surface of the main unit
(top surface of the cooling water tank)
Inside of the front surface of the main unit
(front surface of the cooling water tank)
Inside of the left side surface of the main unit
(under the CPU board)
Inside of the main unit
(side surface of the high voltage cover (2 places))
(inside of the front surface of the main unit)