Amada ML-2350A-CE, Operation Manual, Page: 171 / 235

4. Commands
171
ML-2350A/2351A
Chapter 5 Laser W
elding by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
Stopping a Laser Light Output
The command (code: $9) to stop a laser light output is explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
ACK or NAK
The Laser accepts the command only when in external communication
control (RS-485 CONTROL) mode. It returns a [NAK] when in any other
control method.
Stopping an Error Signal Output
The command (code: C0) to stop an error signal output is explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
ACK or NAK
The Laser accepts the command only when in external communication
control (RS-485 CONTROL) mode. It returns a [NAK] when in any other
control method.
Resetting the Total Number of Outputs
The command (code: C1) to reset the total number of outputs (SHOT COUNT) is
explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
ACK or NAK
The Laser accepts the command only when in external communication
control (RS-485 CONTROL) mode. It returns a [NAK] when in any other
control method.