Amada ML-2350A-CE, Operation Manual, Page: 127 / 235

3. Operating Procedure
127
ML-2350A/2351A
Chapter 3 Laser W
elding by Laser Controller (P
ANEL
CONTROL)
Introduction Part
Installation
and
Preparation
Part
Operating Part
Maintenance Part
Appendixes
(9) Press the LASER START/STOP button.
Laser light is output.
⇒
Before pressing the LASER START/STOP button, display the SCHEDULE
screen or MONITOR screen and input another registered SCHEDULE number.
With this, laser light is output in the output conditions of this SCHEDULE.
(10) Press the MON button to display the MONITOR screen, and check the laser
output energy (J) and average power (W) of the output laser light.
4
Stopping Laser Welding
CAUTION
During a laser light output or for 5 seconds immediately after a laser light output, do
not turn OFF the MAIN POWER switch. Damage may be caused to the lamp and YAG
rod by insufficient cooling.
(1) Press the "HV" setting button on each screen to set it to OFF.
The high voltage is cut off.
(2) Turn OFF the CONTROL keyswitch.
The key can be pulled out.
(3) Turn OFF the MAIN POWER switch.
The power supply is turned OFF and the POWER lamp goes out.
⇒
Return the key of the CONTROL keyswitch to the laser safety supervisor so that
it can be kept in custody.