Amada ML-2350A-CE, Operation Manual, Page: 159 / 235

4. Commands
159
ML-2350A/2351A
Chapter 5 Laser W
elding by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
Setting Data
The command (code: W) to set welding schedules by specifying equipment No.
and schedule No. is explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
LA1/LA0
Classification No. of the setting (LA1 = tens digit, LA0 = units digit)
99 Settings for the cooler (Set the schedule No. [SH1/SH0] to 00.)
84 Schedule settings for both FIX and FLEX
85 Schedule settings for FIX
86 Schedule settings for FLEX, TIME 01 to 10
87 Schedule settings for FLEX, TIME 11 to 20
88 Schedule settings for FLEX, POWER 01 to 10
89 Schedule settings for FLEX, POWER 11 to 20
75 SEAM setting value SEAM ON/OFF
76 SEAM setting value SHOT 01 to 10
77 SEAM setting value SHOT 11 to 20
78 SEAM setting value POWER 01 to 10
79 SEAM setting value POWER 11 to 20
SH1/SH0
Schedule No. (SH1 = tens digit, SH0 = units digit)
Enter the No. of the schedule you want to change within the data range of
00 to 31.
If □□ (spaces) are entered, the currently selected schedule is used.
DT1/DT0
Data No. (DT1 = tens digit, DT0 = units digit)
• For detailed information on the data No., see "Set Value/Monitor Value
Table" on page 161.
• If “99” is entered, data is written in a batch.
data: (Data No.1), (Data No.2), (Data No.3), ... (the last Data No.)
Insert [,] between individual data.
The monitor data (WATER, SHOT COUNT, GOOD COUNT, ENERGY) will
not be written.
ACK or NAK
When the setting data is within the setting range, [ACK] is returned. When
this data is out of the setting range, [NAK] is returned. This command is
effective only for external communication control. For the other control
methods, [NAK] is returned.