Amada ML-2350A-CE, Operation Manual, Page: 169 / 235

4. Commands
169
ML-2350A/2351A
Chapter 5 Laser W
elding by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
ACK or NAK
Valid only at external communication control. If there is any setting that
cannot be changed, all are invalidated and [NAK] is returned.
Reading the Control Method, SCHEDULE No., Branch Shutter, etc.
The command (code: RS) to read the control method, SCHEDULE No., branch
shutter, high voltage ON/OFF status, guide light ON/OFF status, automatic laser
power value transmission ON/OFF status, etc. is explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
SH1/SH0 Schedule No. (SH1 = tens digit, SH0 = units digit)
cnt
Control method
0: Control by control panel
1: Control by external input/output signals (Output schedules are set on
the laser controller.)
2: Control by external communication control
3: Maintenance mode
4: (Missing number)
5: Control by external input/output signals (Output schedules are set on
the personal computer.)
s1 HV (0: OFF 1: ON)
s2 LD (0: OFF 1: ON)
s3 Resonator shutter (0: OFF 1: ON)
s4 Branch shutter 1 (0: OFF 1: ON)
s5 Branch shutter 2 (0: OFF 1: ON)
s6 Branch shutter 3 (0: OFF 1: ON)
s7 Branch shutter 4 (0: OFF 1: ON)
s8 Branch shutter 5 (0: OFF 1: ON)
s9 Branch shutter 6 (0: OFF 1: ON)
mon
Automatic laser power monitor value transmission (0: OFF 1: ON)
Each time the flashlamp comes on, "00 Laser Power Monitor-Energy, number
of waveform data, etc." on page 165 is sent.
rdy READY status (0: Laser start disabled 1: Laser start enabled)