Amada ML-2350A-CE, Operation Manual, Page: 42 / 235

42
ML-2350A/2351A
2. Fixing the Laser Welder
2. Fixing the Laser Welder
In this laser welder, fixtures are installed to protect the oscillator against
vibrations and shocks during transportation. This section explains how to fix
the laser welder on the floor after clearing the fixturea of the laser oscillator.
Item required
Phillips screwdriver, adjuster pressure fixture, and anchor, etc.
1
Clearing the Fixture
(1) Remove the set screws for panel provided in the upper part of the side surface of
the main unit and bring down the control panel forward.
(2) Remove the top cover.
Remove the set screws for top cover provided on both sides and pull up the top
cover straight upward.
(3) Loosen the screws to clear the fixture, so that the laser oscillator is put in a
remote place from the oscillator base.
⇒ After the fixture is cleared, the laser oscillator is put to a floating status with a
rubber legs. Slight vibrations are absorbed. However, take care not to give a
strong shock.
Top surface of the main unit (when the cover is open)
Top cover
Set screw for top cover
(4 positions in total on both sides)
Control panel
Set screw for panel
At delivery At operation
Fixture
At delivery At operation
Fixture