Amada ML-2350A-CE, Operation Manual, Page: 76 / 235

76
ML-2350A/2351A
1. Setting Welding Schedules
SWITCH 2
1
2
3
4
5 • 6
7
8
Switches the transfer speed of external communication data type assigned to 1 to 8
of "SWITCH 2" to ON or OFF.
1: Switches the data bit length. OFF: 8 bits/ ON: 7 bits
2: Sets whether a parity bit exists or not. OFF: Parity bit/ ON: No parity bit
3: Sets the parity mode. OFF: Even/ ON: Odd
4: Sets the stop bit. OFF: 2/ ON: 1
5 and 6: Set the communication speed.
The following speeds can be set by combining ON and OFF.
5 6 bps
OFF OFF 9600
OFF ON 19200
ON OFF 38400
ON ON (9600)
7: At ON, the automatic laser power monitor value transmission of external
communication becomes ON by default.
8: Unused.
SWITCH 3
1
2 to 4
5
6 to 8
Switches the functions assigned to 1 to 8 of "SWITCH 3" to ON/OFF.
1: Unused.
2, 3, and 4: Sets the acceptance time for laser start signal and schedule signal.
The following speeds can be set by combining ON and OFF.
2 3 4
Acceptance time
ON ON ON
0.1ms
OFF ON ON
ON OFF ON
OFF OFF ON
ON ON OFF 1ms
OFF ON OFF 4ms
ON OFF OFF 8ms
OFF OFF OFF 16ms
5: At ON, pin No.4 (End output) of the EXT.I/O (1) connector is put in a closed circuit
only once after the completion of the set shots. The end signal is also output
when an error occurs during laser output or the laser stop signal is input.
6, 7, and 8: Unused.
SWITCH 4
1 to 6
7 • 8
Switches the functions assigned to 1 to 8 of "SWITCH 4" to ON/OFF.
1, 2, 3, 4, 5, and 6: (Enabled only when the branch shutter is put under independent
control)
Press the setting buttons of "1" to "6" of "SWITCH 4" to set the branch shutter
No. to be operated to ON. "1" to "6" of "SWITCH 4" are associated with branch
shutters 1 to 6. Accordingly, set them to ON within the number of mounted
branch shutters.
7 and 8: Unused.