Amada ML-2350A-CE, Operation Manual, Page: 53 / 235

4. Connecting the Optical Fiber
53
ML-2350A/2351A
Chapter 2 Connections and Preparations of Each Section
Introduction Part
Install
atio
n and
Preparati
on Part
Operating Part
Maintenance Part
Appendixes
2
Connecting to Laser Beam Output Unit
(1) Remove the cap at the end of the optical fiber and blow off dust by using the air
blow.
(2) Insert the key provided on the optical fiber plug along the groove on the output
unit side.
(3) Turn the outer-side ring of the plug in the direction of the arrow to fix the optical
fiber.
⇒ Tighten the ring by hand without using a tool.
⇒
The connector section cannot be bent. Take care not to give excessive force to
this section.
⇒
Keep the recover cap in a clean place in custody. If a dirty cap is mounted again,
this will cause seizure.
Optical fiber
Output unit
Approx. 40mm
Connector section