Zontes ZT310T-M, Руководство по обслуживанию

Страница: 118 / 184

118
/
184
Check the starting relay
1. Operation check
a. Remove the seat cushion, remove the battery box
cover assembly, and pull out the starting relay.
b. Unlock the vehicle, turn the engine shutoff switch to
" ", retract the side bracket, pinch the brake handle
and press the start button. You should hear the sound of
the start relay picking up, otherwise you should check
the start circuit.
2. Check the relay coil
2.1 Input line
Adjust the multimeter to the DC voltage 20V file (if it is
an automatic range multimeter, adjust it to the DC
voltage file). Insert the red test lead into the rubber
sleeve of the yellow/red wire and stick it tightly to the
terminal.
Unlock the vehicle, turn the engine off switch to " ",
and the black test lead can select any bolt connected to
the frame nearby. When the brake handle is pressed
and the start button is pressed, the voltage measured
between the yellow/red wire and the ground wire should
be the battery voltage.
2.2 Ground wire
The vehicle is powered off and locked. Set the
multimeter to the buzzer position, connect one test lead
to the green/red wire, and one to any bolt connected to
the frame. It should be conductive when the start button
is pressed.
3. Check the starting relay
Use a thicker wire to directly connect the 12V battery
to the relay. Use the buzzer file of the multimeter to
measure the green/red and yellow-red wires, which
should be conductive, and should be disconnected after
disconnecting the battery.
4. Disassembly and assembly of the starting relay
Open the black protective cap of the starting relay and
use a 10# sleeve to remove the self-contained M6 nut,
take out the wire and screw it back to the nut to prevent
loss; use the same method to remove the other end.
Unplug the yellow/red and green/red wires.
When re installing, the yellow/red and green/red wires
of the relay correspond to the color of the main cable,
and the nuts are not distinguished. Be sure to close the
protective cap after tightening the nut.
Commutator
Crankshaft