Zontes ZT310T-M, Руководство по обслуживанию

Страница: 41 / 184

41 / 184
f. Pull out the two relay wires.
There are a total of 8 relays, the model is: KH-1A4T.
g. Unplug the two wires of the starting relay. Open the
red and black protective caps of the starting relay, and
remove the nuts with a 10# sleeve.
h. Straighten out the cables in the battery
compartment. For the National IV model, remove the
bolts on both sides (3) with 4# inner hexagon according
to Figure 1, and remove the bushing
⑷
and cushion
rubber
⑸
. For Euro V models, remove the bolts on both
sides (3) with a 4# inner hexagon according to Figure 2.
i. According to this step for National IV models, Euro V
models skip directly to the next step. Use your fingers or
a plastic crowbar to pry the glove box rubber strip
⑺
from one end and remove it. Remove the decorative
buckle
⑻
of the M6 hexagon socket bolt; remove the
bolts on both sides with 4# hex socket
⑶
, remove the
bushing
⑷
and the cushion rubber
⑸
. Remove the 3
bolts
⑼
with a Phillips screwdriver.
j. Remove the decorative buckle
⑻
of the M6
hexagon socket bolt; remove the bolts on both sides
with 4# hex socket
⑶
, remove the bushing
⑷
and the
cushion rubber
⑸
.
k. Grasp the tail skirt of the storage box and pull it
upward obliquely, paying attention to the cables in the
battery compartment. Pull up to see the left side of the
glove box atmosphere lamp thread, unplug the thread
and remove the glove box assembly.
l. Unplug the plug of the stepping motor
①
.
m. Use a short Phillips screwdriver to remove the 2
bolts
①
and the anti-off card
②
that come with the
throttle valve body assembly, and then remove the
stepping motor
⑽
.