Zontes ZT310T-M, Руководство по обслуживанию

Страница: 166 / 184

166
/
184
c. One person uses 14# torx wrench to extend from
under the tail skirt and fix the 1 M10×1.5×55 bolt on the
top of the left rear shock absorber, and one person uses
14# ratchet wrench to remove and fix the left
side from the frame. One M10 nut
⑽
for rear shock
absorption, and a bolt
⑾
of M10×1.5×55 is drawn out.
Use the same method to remove the 1 M10 nut
⑽
that
fixes the right rear shock absorber, one person holds the
frame, and the other uses a rubber suitable
tools to knock out one M10×1.5×55 bolt that fixes the
right rear shock absorber.
d. Two people hold the left and right handlebars and
the frame respectively, push the whole car forward, push
it to a flat and wide place, lay down the side brackets,
and use a rubber stool with a suitable height to pad the
rear pedal bracket on the right side of the vehicle. Point
to keep the vehicle balanced.
5. Install the engine
a. Two people cooperate to push the whole car to a
suitable position, and first place the rear brake caliper on
the whole car on the disc brake disc, being careful not to
knock the shock absorber. Another person holds the
vehicle, and one person adjusts the cradle mounting
hole on the vehicle frame to align with the engine
mounting hole. After aligning, use a suitable tool to
penetrate a M12×1.5×290 bolt
⑻
.
b. One person holds the whole car and slightly lifts the
rear part of the frame, and one person rotates the two
rear shock absorbers to the frame installation groove,
and then rotates the right shock absorber until it is
aligned with the frame installation hole. Pass one
M10×1.5×55 bolt
⑾
, use one M10 nut
⑽
on the left
side to tighten, torque: 30N.m (3.1 kgf.m, 22 lbf.ft).
When installing the left side shock absorber, you need to
slightly shake the frame from side to side until the shock
absorber installation hole is aligned with the frame
installation point, and then use the same method to fix
the left side shock absorber.
c. open the brake pads on the rear brake caliper with
a flat-blade or other suitable tool, then install the brake
caliper on the rear rocker arm, and then install 2 M8×37
bolts
⑹
, use 14# set Tighten the barrel, torque: 24N.m
(2.4 kgf.m, 18 lbf.ft); then connect the wheel speed
sensor plug back to the corresponding position, install a
M6×12 bolt
⑸
, use 4# inner hexagon to tighten ; Finally,
install all the pipes connecting the brake calipers and the
wheel speed sensor into the corresponding clamps, and
arrange the lines.
d. Insert the high-voltage package at the front of the
engine back, and install one M12 nut back on the cradle
to fix the engine, use 17# torx wrench to fix M12 nut
⑼
,
another person uses 15# socket to tighten bolt
⑻
,
torque: 65N.m (6.5 kgf.m, 48 lbf.ft).