Zontes ZT310T-M, Руководство по обслуживанию

Страница: 34 / 184

34 / 184
c. replace the new filter element and sealing strip.
7. Inspection air filter waste oil pipe
Wipe clean the surface of the waste oil pipe and
visually check for liquid. If so, use pliers to remove the
waste oil pipe clamp, clean the waste oil pipe, and then
reinstall it. Pay attention to increase the frequency of
inspection appropriately when the air humidity is high.
8. Reinstall
a. Refer to the steps of removing the filter housing to
install the housing back.
b. Replace the air inlet baffle and the air inlet cover of
the replaced air inlet filter element.
c. Put back the shockproof sponge.
d. Clip M6×16 bolts + flanged b flanged
bushing cushioning glue to the inner step hole of the
engine left cover, and then use a 4# inner hexagon to
penetrate from the outside and hold the bolt
.
e. Align the left bolt with the mounting hole and tighten
it.
f. Before installing other bolts, install the exposed
sponge and plug it back into the left cover.
g. Use 4# inner hexagon to install the other 4 M6×16
bolts + flanged b flanged bushing buffer glue.
Replace the decorative buckle.
●The vehicle must be parked on a flat and stable ground
or a lifting platform.
●The operation can only be performed after the engine
has cooled down completely.
●The air filter element and the engine air inlet element
should be replaced every 10000km (621 mile).