Zontes ZT310T-M, Руководство по обслуживанию

Страница: 70 / 184

70
/
184
dust-proof, sun-proof, and ventilated place; or cover it
with a car jacket to protect the body parts and the tires
better. If you do not drive for a long time, you should
support the vehicle firmly and let the tires hang in the air
to avoid deformation caused by long-term load on the
ground contact.
●Because the tire self-refilling may block the air hole of
the tire pressure monitoring sensor, causing difficulty in
inflation or failure of the tire pressure monitoring, it
should not be used.
1. Check the tires
a. Park the vehicle on a flat and stable ground or a
lifting platform, and put down the main support.
b. Support the front wheel with suitable tools, let the
front tire hang in the air, and then rotate the tire to
carefully check for abnormalities, such as partial wear,
studs, cracks, etc. Clean up the pebbles or other foreign
objects embedded in the tread pattern. Check whether
the tread and sidewall have worn to the mark. If they are
close to or have worn to the mark, replace with a new
tire of the same specification in time. Use a tire pressure
gauge to measure the tire pressure when the tire is cold,
and add or deflate to the standard 260kPa (2.7 kgf/cm2,
37.7 PSI).
b. The height of the wear mark on the tread protrusion
is 1.6mm (0.06 in). The triangle (
△
T.W.I.) mark on the
sidewall indicates the location of the wear bar. If the
wear reaches the mark point, it means that it has been
worn to the limit. If you continue to drive, there will be a
safety hazard. You must replace with new tires of the
same specification.
c. The inspection of the rear tires is the same as that
of the front tires and will not be repeated here.
2. Replace tires
a. Replace the front tire
The front wheel assembly can be removed by
referring to the description of the steps for
disassembling the front wheel assembly in the "Front
Fork Assembly" of this manual. Use a tyre picker to
remove the tire. When disassembling, pay attention to
avoiding the valve position. Do not use a crowbar to pry
the tire at the valve position to avoid damage to the tire
pressure sensor. Before pressing the tire, install it
according to the direction of rotation indicated by the
sidewall, and aim the light point with the yellow mark at
the position of the valve. After replacing a new tire or
repairing a tire, the dynamic balance needs to be re-
balanced to prevent the front wheel from shaking due to
unbalance and affecting the driving experience
b. Replace the rear tire
Refer to the previous operation of replacing the rear
brake disc to remove the rear wheel assembly. Other
operations are similar to the replacement of the front
tires, and will not be repeated here.
Steering mechanism
Caution:
●Regularly inspect the steering mechanism according to
the requirements of the regular maintenance table.
●Park the vehicle on a flat and stable ground or a lifting
platform, and put down the main support.