Zontes ZT310T-M, Руководство по обслуживанию

Страница: 155 / 184

155
/
184
b. Finally, put the direction back on the middle cover.
●Attention should be paid when disassembling the
direction handle cover to prevent damage to the buckle.
●After installation, check whether the throttle cable is
assembled in place and whether the return position is
flexible.
●Self -tapping screws need to be installed vertically and
the torque cannot be too large.
●After installation, check the switch buttons of the left
and right handle switches and the left and right auxiliary
handle switches to check whether they can be used
normally, and check whether there is a pressure line.
Replace the front wheel
Caution:
●Be careful not to damage the ABS coil when
disassembling.
●After removing the front wheel, do not press the brake
handle.
●The vehicle must be parked on a flat and stable ground
or a lifting platform.
●It is forbidden to use a high -pressure water gun to flush
against the oil seal at close range.
1. Remove the front wheel assembly
a. Lay down the main support, and then use a jack or
a suitable device to support the whole vehicle to keep
the front wheels off the ground.
b. Use 6# inner hexagon to loosen the two M8×35
bolts at the front left shock absorber (1), then use 17#
inner hexagon to remove the front wheel shaft (2), and
remove the front wheel and 2 bushings.
2. Install the front wheel assembly
a. Separate the two brake pads in the brake caliper
with a single-size batch. If the resistance is too large and
the two brake pads cannot be separated, please refer to
the method of "Adding Brake Fluid" to remove the upper
cover of the disc brake oil cup and then separate it. 2
brake pads.
b. Put the front wheel in the middle of the front shock
absorber, shake the front wheel left and right to make
the disc brake disc snap into the middle of the brake
pad, align the shaft hole, insert the front wheel shaft
⑵
,
tighten the front wheel shaft with 17# inner hexagon,
torque: 50N. m (5.1 kgf.m, 37 lbf.ft), after the front wheel
axle is tightened, there is a gap of about 2.5mm
between the left side bushing of the front wheel and the
shock absorber; use 6# inner hexagon to tighten the two
front left shock absorbers M8×35 bolt
⑴
, torque: 20N.m
(2.0 kgf.m, 15 lbf.ft).
●After the front wheel is installed, please press the brake
handle repeatedly until the brake restores the braking
effect.
●Contaminated disc brake d iscs and disc brake pads will
reduce the braking effect. Please replace with new disc
brake discs and clean the contaminated brake discs.
●After each front wheel replacement, you must go to a
professional organization for dynamic balance testing.
●Becaus e the tire self-refilling may block the air hole of
the tire pressure monitoring sensor, causing difficulty in
inflation or failure of the tire pressure monitoring, it should
not be used.