Zontes ZT310T-M, Руководство по обслуживанию

Страница: 30 / 184

30 / 184
2. Maintenance
Know Before Service
1. Use good quality tools, or special tools and fixtures designed by our company. The use of inferior tools may cause
damage to parts, peeling of plating, improper assembly, etc.
2. The O-rings, paper gaskets, copper gaskets, and component seals used for sealing must be replaced before
assembly.
3. Fasteners with torque requirements need to use a torque wrench to check the torque; if the torque is not required,
refer to the general torque value recommended by general fasteners.
4. Clean up before assembly; after assembly, check whether the assembly is correct and in place.
5. The vehicle should be parked balanced and pay attention to safety during disassembly and assembly. Including but
not limited to the use of electric tools, hand tools, pneumatic tools, hydraulic tools, and handling. Prevent contact with
skin, eyes, burns, electric shocks, etc.
6. The replaced oils, liquids, batteries, etc. must be recycled and handed over to a qualified organization for disposal;
it is forbidden to dump them at will to pollute the environment or water sources.
7. Swallowing or inhaling coolant, brake fluid, etc. will cause certain harm to the human body. Any exposed skin such
as hands and face should be cleaned thoroughly after each addition. If swallowed by mistake, immediately contact the
poison control center or hospital; if inhaled, immediately go to a ventilated environment. If it accidentally splashes into
the eyes, immediately rinse the eyes with a large amount of running water and seek medical advice or consultation in
time. Keep away from children and pets.
8. If you need to clean or wash the body parts of the vehicle, you should use neutral car wash fluid or tap water,
diesel, kerosene, etc. Acidic or alkaline car wash fluid will cause irreversible corrosion of the surface paint,
electroplating surface, and anodized surface of the parts; gasoline will cause premature aging or hardening of
sealants, gaskets, and rubber parts, reducing the service life. Non-woven fabrics should be used for wiping with no
residue. Ordinary rags may leave cloth scraps or wool, etc., which may affect the assembly or cause other adverse
effects.
9. The following is the instructions for disassembly and assembly of expansion nails.
①
Press the center cylinder with 4# inner hexagon or other tools, you can hear a sound or the center cylinder moves
axially by 2mm (0.079 in);
②
Pry open the gap with a blade, nail or carving knife, etc. and remove it; if there is space It is allowed to reach to the
back to push out;
③
Pinch the outer ring with two fingers and push the center cylinder up to the initial position;
④
Pinch the center cylinder with two fingers to install the expansion nails to the installation position;
⑤
The outer ring fits the connected parts ; If it does not fit, check for misalignment;
⑥
Press the center cylinder with your fingers or other tools, and you can hear a sound or the top of the center cylinder
is almost flush with the top surface of the outer ring, indicating that the assembly is in place.
Only part of the basic requirements for matters needing attention, prevention of accidental injury, etc. can be listed;
it is not possible to list all situations in detail. Be vigilant during disassembly and assembly to prevent accidents.