Zontes ZT310T-M, Руководство по обслуживанию

Страница: 81 / 184

81
/
184
Side bracket
Caution:
●Park the vehicle on a flat and stable ground or a lifting
platform, and put down the main support.
●When disassembling and installing the spring, it is
necessary to prevent the spring from flying off suddenly
and causing personal injury.
1. Check
1. Side bracket 2. Side bracket spring 3. Side bracket
flameout switch
①
Parking position
②
Driving position
a. Check whether the side bracket spring is damaged
and whether the elastic force is normal.
b. Check whether the side bracket rotates normally.
Turning to the angle shown in Figure 1 should be able to
automatically turn to the parking space under the spring
force; when the angle in Figure 2 is turned to the parking
space automatically. If necessary, remove the side
bracket for lubrication.
c. Check whether the flameout switch function is
normal.
The vehicle should not be started when the side
bracket is lowered (parking position); the vehicle cannot
be started when the side bracket is retracted (driving
position) without pinching the front or rear brake handle;
After starting the vehicle, put down the side brackets,
and the flame should be automatically turned off,
otherwise it is necessary to troubleshoot the flameout
switch or brake switch failure.
d. Check whether the side bracket mounting plate is
deformed or cracked.
2. Lubrication
a. Put away the side bracket so that the spring is in
the shortest position for easy disassembly.
b. The thick steel wire can be rolled into a circle and
put into the spring
⑴
pull hook. Pay attention to ensure
that the steel wire cannot loose or fall apart during the
pulling process.
C. Grasp the side bracket with one hand, and pull it in
the direction of the arrow with the other hand to remove
the spring.
d. Put down the side bracket, and use a 14# sleeve or
torx wrench to remove the nut
⑵
counterclockwise.
After holding the side bracket firmly, use a 14# sleeve to
remove the bolt
⑶
counterclockwise, and take off the
side bracket.
e. Remove the side bracket bushing
⑷
from the frame.
f. Use diesel or kerosene, or a clean cloth to wipe off
the remaining grease. Apply a proper amount of grease
to the two installation planes inside the side bracket and
the surface that matches the flameout switch, and try not
to apply it to the threaded holes.