Zontes ZT310T-M, Руководство по обслуживанию

Страница: 154 / 184

154
/
184
e. Use 6# inner hexagon to remove the M6×80 bolt
⑽
, pull out the right balance weight and the rubber
sleeve of the right hand in the direction of the arrow, use
the same method to pull out the left balance weight,
soak in hot water for about 10 minutes before using
Blow the dust gun into the gap between the left hand
handle and the direction handle tube according to the
arrow, then pull the direction handle and the left hand
handle in the opposite direction, and then take out the
left hand handle rubber case.
Right:
Left:
3. Installation of the direction component
a. Apply 263 thread fastening glue to the inner wall of
the rubber sleeve in the left hand, and the length of the
glue is 1/3 of the rubber sleeve of the handle, and then
put the rubber in the left hand into the direction handle;
the inner wall of the rubber sleeve in the right hand does
not need to be coated with the thread fastening glue.
Just load it. Be careful not to remove the throttle cable
on the rubber sleeve with your right hand. Reinstall the
left and right balance weights according to the
disassembly steps, and tighten the M6×80 bolt
⑽
with
a 6# inner hexagon.
b. When installing the left and right handle switches,
you need to align the bolts (8c) and (9c) with the
positioning holes
⑥
and then tighten them with a cross
screw. Use a 5# inner hexagon to tighten the bolts (8a)
that fix the left and right handle switches in turn, (8b),
(9a), (9b).
c. When installing the auxiliary handle switch, align
the joint surface of the auxiliary handle switch and the
main pump of the disc brake with the triangle mark on
the handle switch, and then tighten the 4 M6×30 bolts
with a 5# inner hexagon.
d. Snap the upper brackets
⑦
,
⑧
, and
⑨
into the
lower part of the direction control cover, buckle the
pressure block, tighten 4 M8×35 bolts with 6# inner
hexagon, and use 5# inner hexagon to fix 1 non-
standard M6 Tighten the ×16 bolt
⑶
, be careful not to
miss the bushing
⑸
and cushion rubber
⑹
; then use a
5# inner hexagon to install a non-standard M6×16 bolt
⑶
+ spring washer
⑷
to fix the mobile phone bracket
installation bracket.
4. Installation of the direction handle cover
a. When installing the upper cover in the direction, first
install the upper cover in the appropriate position, first
buckle the buckles a, b, and c on the front of the upper
cover in the direction, and then buckle the back buckles
③
,
④
,
⑤
and The buckles
①
and
②
on both sides
should be fastened. After installation, the upper cover
should be tightly fitted with the lower cover, and the gap
should be even. Finally, tighten the 2 self-tapping
screws at the lower cover (1) with a flat-head
screwdriver.