![background image](http://html1.mh-extra.com/html/zeiss/lightsheet-z-1/lightsheet-z-1_operating-manual_927692051.webp)
Lightsheet Z.1
Carl Zeiss
02/2013
000000-1790-528
47
3.10
Removing and Inserting the Reflector Turret for Emission Selection
The reflector turret (Fig. 37/
5
) can be accessed by opening the left-hand-side front system door
1
).
After the reflector turret for emission selection has been exchanged, the
Automatic Detector
Alignment
should be performed. The ZEN software should be restarted if the reflector turret was
removed, while ZEN was still running.
To remove, first of all turn the silver-colored lever (Fig. 37/
2
), then pull-out the reflector turret by using
the grip (Fig. 37/
6
).
When inserting, it is recommended that the reflector turret first of all be held by the short grip (Fig. 37/
5
)
and inserted into the guide rail (Fig. 37/
3
) and then pushed in as far as it will go using the long pull rod
6
). Return the locking lever to its original position. Finally, close the system door.
The filters are not push and click filters and cannot be taken out as a whole. The filter cube and the
beam splitter were installed and aligned in the factory. Do not try to take out single filter cubes or
beam splitters, it will damage the filters and the alignment, rendering the system in the worst case
unusable.
1
Front system door
4
Reflector turret
2
Silver-colored lever
5
Short grip
3
Guide rail
6
Grip
Fig. 37
Removing and inserting the reflector turret for emission selection
Содержание Lightsheet Z.1
Страница 1: ...Lightsheet Z 1 Operating Manual February 2013 ZEN 2012 black edition ...
Страница 4: ......
Страница 170: ......
Страница 427: ...Lightsheet Z 1 Overview ...