Toshiba e-studio 2555c, Руководство по обслуживанию

Страница: 728 / 1558

e-STUDIO2555C/3055C/3555C/4555C/5055C © 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 172
[CC02] Stack exit roller nip home position detection error
MJ-1036
[CC20] Saddle communication error
MJ-1108
[CC30] Stack transport motor abnormality
* You receive a [CC30] error when the [EA70] error occurs three times in succession.
MJ-1107
Replacement part Measure
Stack exit roller shift motor (M6)
Stack exit roller home position
sensor (S13) The stack exit roller home position sensor (S13) does not detect
that the exit roller is not at the upper position after the stack exit
roller motor (M6) has been driven in the specified time when the
exit roller is moved down.
The stack exit roller home position sensor (S13) does not detect
that the exit roller is at the upper position after the stack exit
roller shift motor (M6) has been driven in the specified time
when the exit roller is moved up.
Classification Contents
Finisher related service call Saddle communication error
Check Item Measure
Interface PC board (I/F) • Connector check
• Harness check
Finisher control PC board (FIN) • Connector check
• Harness check
Saddle control PC board (SDL) • Connector check
• Harness check
Interface PC board (I/F) Board check
Finisher control PC board (FIN) Board check
Saddle control PC board (SDL) Board check
Finisher control PC board (FIN) Update the firmware version of the finisher control PC board
(FIN).
Saddle control PC board (SDL) Update the firmware version of the saddle control PC board
(SDL).
Replacement part Measure
Interface PC board (I/F)
Finisher control PC board (FIN)
Saddle control PC board (SDL)
Classification Contents
Finisher related service call Stack transport motor abnormality: The stack transport motor is
not rotating or the stack transport belt is not moving normally.
Check Item Measure
Stack transport belt If there is mechanical problem when the stack transport belt is
moved, fix the mechanism.