Toshiba e-studio 2555c, Руководство по обслуживанию

Страница: 441 / 1558

6
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2555C/3055C/3555C/4555C/5055C
SETTING / ADJUSTMENT
6 - 15
[C] Secondary scanning data writing start position
Performing the code 05-4402 covers this adjustment for all paper sources.
The adjustment for each paper source is also available.
For all paper sources
For each paper source
(1) While pressing [0] and [5] simultaneously, turn the power ON.
→
(Adjustment Mode)
(2) Press [98] ([3] for duplexing)
→
[FAX]. (A grid pattern with 10 mm pitch is printed out.)
(3) Measure the distance C from the leading edge of the paper to the 6th line of the grid pattern.
*
Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance C is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance C again.
<Procedure>
(Adjustment Mode)
→
(Key in the code shown above)
→
[START]
→
(Key in an acceptable value shown above)
→
[OK] or [INTERRUPT] (Stored in memory)
→
“100% A” is displayed
→
Press [98] ([3] for duplexing)
→
[FAX]
→
(A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance C becomes (approx. 0.10 mm/
step).
Code Paper size Acceptable value Remarks
4402 A3/LD 0 to 200 Performs the adjustment for all paper sources.
Order for
adjustmen
t
Paper source Code Paper size
Acceptabl
e value
Remarks
1 1st drawer 4058 A4/LT 0 to 100
2 2nd drawer 4059 A3/LD 0 to 100
3 3rd drawer 4060 A4/LT 0 to 100
4 4th drawer 4560 A4/LT 0 to 100
5 Bypass feed 4061 A4/LT 0 to 100
6
Duplexing 4062 A3/LD 0 to 100
Paper fed from the 2nd
drawer