Toshiba e-studio 2555c, Руководство по обслуживанию

Страница: 1043 / 1558

13
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2555C/3055C/3555C/4555C/5055C
EXTERNAL COUNTERS
13 - 5
13.3 Notices
13.3.1 Setting code
Each signal will be enabled by configuring the setting code “08-9016” (Counter installed externally).
08-9016
0: No external counter (Default)
1: Coin controller
2: Card controller (For Japan only)
3: Mechanical counter
5: Coin controller supporting ACS
13.3.2 Setting value change and restrictions when using the Card
Controller
1. Setting value
- 08-9016 (Counter installed externally): Set to “2” (Card controller).
- 08-9017 (Setting for counter installed externally): It should be charged precisely according to the
usage.
Example: To charge only when copies are made, set to “1”.
- 08-6011 (Definition setting of large sized paper): Set to "0" if only A3 and LD are regarded as
large size. Set to "1" if B4, LG, FOLIO and COMP are done so as well.
13.3.3 Setting value change and restrictions when using the coin
controller
1. Setting value
- 08-9016 (Counter installed externally): Set to “1” (Coin controller). The coin controller supporting
ACS (Auto Color Selection) can be connected by setting to "5" (Coin controller supporting ACS/
mixed-size). However, operation is not guaranteed unless the specification for the ACS timing is
met.
- 08-9017 (Setting for counter installed externally): It should be charged precisely according to the
usage.
Example: To charge only when copies are made, set to “1”.
- 08-6011 (Definition setting of large sized paper): Set to "0" if only A3 and LD are regarded as
large size. Set to "1" if B4, LG, FOLIO and COMP are done so as well.
13.3.4 Installation of External Counter
It is not allowed to install more than one external counter (Card Controller and Coin Controller) at the
same time.
13.3.5 Setting value
The Key Counter used for current models is not supported in this equipment, but the circuit for driving
the counter has been mounted. The mechanical counter can be used by setting as below, however the
harness for connecting it has not been provided as an option.
1. Setting value
- 08-9016 (Counter installed externally): Set to "3" (Mechanical counter).
- 08-9017 (Setting for counter installed externally): It should be charged precisely according to the
usage.
Example: To charge only when copies are made, set to "1".
- 08-6011 (Definition setting of large sized paper): Set to "0" if only A3 and LD are regarded as
large size. Set to "1" if B4, LG, FOLIO and COMP are done so as well.