Communications Using iPort or RPComm
Using RPComm
D-26
Partisol 2000
i
and Partisol 2000
i
-D Instruction Manual
Thermo Fisher Scientific
Figure D–24.
Dialing Properties Screen
15.
Fill in the required information on the Dialing Properties screen.
Verify that the “Number to be dialed” shown at the bottom of the
screen matches the phone number as it should be dialed. If the phone
number is not correct, there is an error on this screen or you may have
incorrectly entered the phone number on the AK Protocol Setup
screen.
16.
Select “OK” when the proper settings have been confirmed. This will
return you to the AK Protocol Setup screen.
17.
Select “OK” while in the AK Protocol Setup screen. This will return
you to the Connection Type screen. To finish the connection setup,
select “OK” while in the Connection Type screen.
18.
To connect to your Sampler through the modem, highlight the
connection name on the Connect List screen (
Figure D–20
) and then
select the Connection icon on the tool bar. The modem connection
will now be initiated. When communication is established, the Partisol
2000
i
Main screen will be displayed (
Figure D–25
).
Note
If the connection is successful, the unit’s serial number will be
displayed at the top of the screen. If the connection is not successful or if
there is no instrument attached, then the serial number area will be blank
or will display “99999.” If the modem loses its connection, wait at least 1
minute before trying to establish another connection. This allows the
modem to reset itself.
▲