Suzuki RA410, Руководство пользователя

Страница: 121 / 761

3B1-14 ELECTRICAL POWER STEERING (P/S) SYSTEM
DTC 41/42/43/44/45 MOTOR CIRCUIT FAILURE
1. To main fuse
2. Ignition switch
3. “P/S” fuse (30A) in fuse box
4. “IG METER” fuse (15A) in fuse box 5. P/S control module
6. Motor and clutch
7. Connector “A”
8. Connector “B”
7
8
STEP ACTION YES NO
1 Was “SYSTEM CHECK FLOW TABLE” performed? Go to STEP 2. Go to “SYSTEM
CHECK FLOW
TABLE” in this section.
2 1) Remove steering column hole cover.
2) Check proper connection for 4-pin (“B”) connector
to P/S control module.
3) If OK, start engine.
4) Check voltage between “B1” terminal and body
ground and “B2” terminal and body ground with
“B” connector connected to P/S control module.
Are they 5 – 7 V with steering wheel held at posi-
tion for vehicle to run straight?
Go to STEP 3. Repair poor connec-
tion, high resistance,
open or short to power
circuit or ground in
“B1” or “B2” circuit.
3 1) Check motor and its circuit. Refer to ON-VE-
HICLE INSPECTION of MOTOR AND CLUTCH.
Is motor in good condition?
Substitute a known-
good P/S control mod-
ule and recheck.
Replace steering
column assembly and
recheck.
Fig. for Step 2
“B1” “B2”