Suzuki RA410, Руководство пользователя

Страница: 9 / 761

CAUTION:
Even when the accident was light enough not to cause
air bags to activate, be sure to inspect system parts
and other related parts according to instructions un-
der “Repair and Inspection Required after an Acci-
dent” in SECTION 10B.
When servicing parts other than air bag system, if
shocks may be applied to air bag system component
parts, remove those parts beforehand.
When handling the air bag (inflator) modules (driver
and passenger), seat belt pretensioners (driver and
passenger) or SDM, be careful not to drop it or apply
an impact to it. If an excessive impact was applied,
never attempt disassembly or repair but replace it with
a new one.
When grease, cleaning agent, oil, water, etc. has got
onto air bag (inflator) modules (driver and passenger)
or seat belt pretensioners (drive and passenger), wipe
off immediately with a dry cloth.
Air bag wire harness can be identified easily as it is
covered with a yellow protection tube. Be very careful
when handling it.
When an open in air bag wire harness, damaged wire
harness, connector or terminal is found, replace wire
harness, connectors and terminals as an assembly.
Do not apply power to the air bag system unless all
components are connected or a diagnostic chart re-
quests it, as this will set a diagnostic trouble code.
Never use air bag system component parts from
another vehicle.
When using electric welding, be sure to temporarily
disable air bag system referring to “Disabling Air Bag
System” described in “Service Precautions” under
“On-Vehicle Service” in SECTION 10B.
Never expose air bag system component parts directly
to hot air (drying or baking the vehicle after painting)
or flames.
WARNING / CAUTION labels are attached on each part
of air bag system components. Be sure to follow the
instructions.
After vehicle is completely repaired, perform “Air Bag
Diagnostic System Check” described in “Diagnosis”
in SECTION 10B.
0A-6 GENGERAL INFORMATION