Suzuki RA410, Руководство пользователя

Страница: 139 / 761

3) Install combination switch/contact coil and combination switch
assembly (3) to steering column.
NOTE:
For vehicle with air bag system
New contact coil and combination switch assembly is sup-
plied with contact coil set and held at its center position
with a lock pin (1) and seal (2). Remove this lock pin after
installing contact coil and combination switch assembly to
steering column.
2
1
3
4) Install steering column upper cover (2) and lower cover (3), and
then tighten steering column cover screws (1).
3
2
**1
*1
* : Standard screw
** : Tapping screw
CAUTION:
When installing lower cover (3) and upper cover (2),
be careful so that combination switch/contact coil
and combination switch lead wire is not caught be-
tween covers.
5) Tighten steering column mounting nuts (“A”, “B”, “C”) by hand
and then tighten them to specified torque in the order
(“A”–“B”–“C”) in the figure.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
“A”, (a)
“C”, (a)
“C”, (a)
“B”, (a)
6) Install steering column hole cover (1).
7) Install steering wheel to steering column. Refer to STEERING
WHEEL in this section.
1
3C-10 STEERING WHEEL AND COLUMN