Suzuki RA410, Руководство пользователя

Страница: 746 / 761

SDM
WARNING:
During service procedures, be very careful when han-
dling a Sensing and Diagnostic Module (SDM).
Be sure to read SERVICE PRECAUTIONS in this section
before starting to work and observe every precaution
during work. Neglecting them may result in personal in-
jury or inactivation of the air bag system when neces-
sary.
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to DISABLING AIR BAG SYS-
TEM of SERVICE PRECAUTIONS in this section.
3) Remove front and rear center console boxes (1, 2) by removing
screws and clips.
4) Disconnect SDM connector (6) from SDM (3).
5) Remove SDM (3) (with SDM plate (5)) as an assembly from ve-
hicle.
INSPECTION
CAUTION:
Do not connect a tester whatever type it may be.
Never repair or disassemble SDM (3).
If SDM has been dropped, or if there are cracks, dents
or other defects in the case or plate, replace it with a
new one.
Check SDM (3) and SDM plate (5) for dents, cracks or deformation.
Check SDM connector (6) for damage, cracks or lock mechanism.
Check SDM terminal for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
INSTALLATION
For installation, reverse removal procedure, nothing following
points.
Ensure that arrow (4) on the SDM (3) is pointing toward the front
of the vehicle.
Tighten SDM bolts to specified torque.
Tightening Torque
(a): 6 N·m (0.6 kg-m, 4.5 lb-ft)
Connect SDM connector (6) to SDM (4) securely.
Enable air bag system. Refer to ENABLING AIR BAG SYSTEM
of SERVICE PRECAUTIONS in this section.
CAUTION:
Do not separate SDM (3) and SDM plate (5).
1
2
(a)
3
(a)
6
4
5
FOREWORD
AIR BAG SYSTEM 10B-51