Suzuki RA410, Руководство пользователя

Страница: 504 / 761

18) Remove engine rear mounting with stiffener and brackets. A
A
C
C
CC
C
B
B
A: To vehicle
body
B: To engine
lower case
C: To T/M case
19) Remove engine left side mounting bracket nuts (1).
20) Lower vehicle and support transmission jack.
21) Remove lower side 2 transmission to engine bolt and nut.
22) Remove other attached parts from transmission, if any.
23) Pull out transmission so as to disconnect input shaft from
clutch disc and then lower it.
1
REMOUNTING
Reverse dismounting procedure to remount T/M assembly noting
the following point.
CAUTION:
Care should be taken not to scratch oil seal lip with
drive shaft while raising transmission.
Do not hit drive shaft joint with hammer installing
it into differential gear.
Use specified torque as given below:
Push in left side drive shaft joint fully so as to engage snap ring
of shaft with differential gear.
A
A
3
2
4
C
C
CC
C
B
B
5
1
A: To vehicle
body
B: To engine
lower case
C: To T/M case
MANUAL TRANSMISSION 7A-11
Tightening Torque N·m kg-m lb-ft
Transmission to engine bolts and nut
Engine left side mounting bracket
nuts (1)
55 5.5 40.0
Engine rear mounting bolts (2)
Engine rear mounting bracket bolts
(to engine lower case) (3)
Engine rear mounting bracket bolts
(to T/M case) (4) 50 5.0 36.5
Engine rear stiffener bolts (5)
Ball stud bolt and nut 60 6.0 43.5
Stabilizer mounting bolts 45 4.5 32.5
Stabilizer bar link nut 68 6.8 49.0
Transmission control cable bracket
bolts
23 2.3 16.5
Clutch release arm bolt and nut 13 1.3 9.5