Suzuki RA410, Руководство пользователя

Страница: 200 / 761

9) Apply grease to inside of outer race (1), then install housing,
joint it with boot and fit boot to outer race.
After fitting boot, insert screwdriver into boot on outer race side
and allow air to enter boot so that air pressure in boot becomes
the same as atmospheric pressure.
1
10) When fixing boot (1) to outer race (2) with boot band (3) , adjust
so that measurements become as indicated below.
Length “a”: 144.5 – 154.5 mm (5.69 – 6.08 in.) MT Vehicle
151 – 161 mm (5.94 – 6.34 in.) AT Vehicle
CAUTION:
To prevent any problem caused by washing solu-
tion, do not wash joint boots and tripod joint ex-
cept its housing. Degreasing of those parts with
cloth is allowed.
To ensure full performance of joint as designed, be
sure to distinguish between two types of grease in
repair set and apply specified volume to respec-
tive joint. Refer to the previons page for identifica-
tion of the grease.
Bend each boot band against forward rotation.
Do not squeeze or distort boot when fastening it
with bands.
Distorted boot caused by squeezing air may re-
duce its durability.
1
2
3
“A”
“B”
“A”: Fill grease (NTG2218 labeled tube included in spare part)
60 – 80 g (2.1 – 2.8 oz)
“B”: Fill grease (No label tube included in spare part)
75 – 95 g (2.6 – 3.4 oz)
4A-8 FRONT DRIVE SHAFT