ELECTRICAL POWER STEERING (P/S) SYSTEM
3B1-13
DTC 22 ENGINE SPEED SIGNAL CIRCUIT FAILURE
1. To main fuse
2. Ignition switch
3. “P/S” fuse (30A) in fuse box
4. “IG METER” fuse (15A) in fuse box
5. ECM/PCM
6. P/S control module
7. Connector “A”
7
STEP
ACTION
YES
NO
1
Was “SYSTEM CHECK FLOW TABLE” performed?
Go to STEP 2.
Go to “SYSTEM
CHECK FLOW
TABLE” in this section.
2
1) Recheck DTC with engine running.
Is DTC 22 indicated?
Go to STEP 3.
It is nothing abnormal
for DTC 22. System is
in normal condition.
3
1) Check proper connection to P/S control module
and ECM at each “Br” wire terminal (P/S control
module side: “A5” terminal, ECM/PCM side: Re-
fer to in SECTION 6E), then check intermittent
trouble. Refer to INTERMITTENT TROUBLE in
SECTION 0A.
2) If they are OK, check high resistance, open or
short to power circuit or ground in “Br” wire cir-
cuit.
Is check result in good condition?
Substitute a known-
good P/S control mod-
ule and recheck.
Repair.
Содержание RA410
