Suzuki RA410, Руководство пользователя

Страница: 650 / 761

10) Using knife (1), smoothen adhesive (2) remaining on body
side (3) so that it is 1 to 2 mm thick all around.
NOTE:
Before using knife (1), clean it with alcohol or the like to
remove oil from it.
11) When reusing windshield, remove the adhesive (1) from it, us-
ing care not to damage primer coated surface (2).
INSTALLATION
1) Using cleaning solvent, clean windshield edge where wind-
shield glass is to be adhered. (Let it dry for more than 10 min-
utes.)
2) Install new glass stoppers (1) (2 pcs) to lower side of windshield.
1
3
3) To determine installing position of glass (1) to body (2), position
glass (1) against body (1) so that clearance (a) between upper
end of glass (1) and body (2) is about 6 mm (0.236 in.) and clear-
ances (a) between each side end (right & left) of glass (1) and
body (2) are even. Upper clearance can be adjusted by moving
stoppers position. Then mark mating marks on glass (3) and
body as shown.
2
1
4) Clean contact surfaces of old adhesive, paint or bare metal thor-
oughly.
If surfaces of paint or bare metal come out, apply primer for body
with caution not to apply primer to surface of adhesive remain-
ing on body.
NOTE:
Be sure to refer to primer maker’s instruction for proper
handling and drying time.
Do not touch body and old adhesive surfaces where glass
is to be adhered.
1. Do not apply primer
2. Primer
3. Apply primer
4. Old adhesive
9-8 BODY SERVICE