Suzuki RA410, Руководство пользователя

Страница: 188 / 761

When the measured runout exceeds the specification and correc-
tion by the balancer adjustment is impossible, replace the wheel.
If the reading is affected by welding, paint or scratch, it should be
ignored.
Radial
runout limit
Lateral
runout limit
1.14 mm
(0.045 in.)
1.40 mm
(0.055 in.)
Steel wheel
MAINTENANCE AND MINOR
ADJUSTMENTS
WHEEL MAINTENANCE
Wheel repairs that use welding, heating, or peening are not ap-
proved. All damaged wheels should be replaced.
WHEEL ATTACHING STUDS
If a broken stud is found, see Section 3E (rear) or Section 3D (front)
for Note and Replacement procedure.
MATCHED TIRES AND WHEELS
Tires and wheels are matchmounted at the assembly plant.
This means that the radially stiffest part of the tire, or “high spot”,
is matched to the smallest radius or ”low spot” of the wheel.
This is done to provide the smoothest possible ride.
The “high spot” of the tire is originally marked by paint dot (1) on
the outboard sidewall. This paint dot will eventually wash off the
tire.
The “low spot” of the wheel is originally marked by paint dot (2) on
the wheel rim-flange. Properly assembled, the wheel rims’ paint
dot should be aligned with the tires’ paint dot as shown in left figure.
Whenever a tire is dismounted from its wheel, it should be re-
mounted so that the tire and wheel are matched. If the tire’s paint
dot cannot be located, a line should be scribed on the tire and
wheel before dismounting to assure that it is remounted in the
same position.
1
2
WHEELS AND TIRES 3F-3