Suzuki RA410, Руководство пользователя

Страница: 731 / 761

10B-36 AIR BAG SYSTEM
DTC 43 – DRIVER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND and 47 –
PASSENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND
STEP ACTION YES NO
1 1) With ignition switch OFF, remove center
pillar inner garnish of applicable side
then disconnect seat belt pretensioner
(“F” or “G”) connector.
2) Check proper connection to applicable
seat belt pretensioner at terminals in “F”
or “G” connector.
3) If OK then connect Special Tool (B) to
seat belt pretensioner (“F” or “G”) con-
nector disconnected at the step 1).
4) With ignition switch ON, is DTC 43 or 47
still current?
Go to Step 2. 1) Ignition switch OFF.
2) Replace seat belt preten-
sioner (retractor assem-
bly) (Refer to SECTION
10).
2 1) With ignition switch OFF, disconnect
Special Tool (B) and SDM (“A”) connec-
tor.
2) Measure resistance between “A11” or
“A6” and “A17” terminals.
3) Is resistance 1 k or more?
Substitute a known-good
SDM and recheck.
DTC43:
Repair short “G/O” or “G/Y”
wire circuit to ground.
DTC47:
Repair short from “Bl/O” or
“Bl/Y” wire circuit to ground.
Fig. for Step 1 and 2
“F”, “G”
(B)
Fig. for Step 2
For DTC 43
For DTC 47
“A6”
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE), if any.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.