A-Tach # 50092
Designed for:
Jaguar I-Pace 2019 - 20__
ST-1
A
-Tach
Mobile Device Mounts
NOTICE:
A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash
BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed
BEFORE
a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the two seams illustrated
with the arrows in the photo.
(2) Insert the seam tool into the seam between the
padded dash top and the top of the frame around
the two center vents.
(3) Remove the covering from the tape. The tape
will not leave any residue if the mount is removed
in the future. Inert the top angled edge of the
mount into the seam next to the seam tool.
(4) Remove the seam tool from the top seam and
insert the seam tool into the seam between the
display and the bottom of the frame around the
center vents.
See additional instructions on the back side.
