Strautmann Giga-Vitesse CFS 3602, Руководство по эксплуатации

Страница: 73 / 327

Safety instructions
73 Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18
3.4.5 Propeller shafts
•
Exclusively use the propeller shaft specified or delivered by Strautmann and equipped with
proper protective devices!
•
Read and observe the operating instructions for the propeller shaft! Proper use and
maintenance of the propeller shaft prevent serious accidents.
•
The protective tube and the protective cone of the propeller shaft must be undamaged and the
protective cover of the tractor and machine propeller shaft must be mounted and in proper
condition! The safety and protective devices of the extended propeller shaft must overlap by at
least 50 mm. If not, do not power the machine via the propeller shaft.
•
Working with damaged protective devices is not allowed!
•
Mounting and dismounting of the propeller shaft is only allowed

with the propeller shaft switched off

with the tractor engine turned off

with the ignition key pulled out

with the parking brake applied
•
Always ensure proper mounting and securing of the propeller shaft!
•
Never use the propeller shaft without protective device or with a damaged protective device.
•
Always mount the wide-angle joint at the pivot point between tractor and machine when using
wide-angle propeller shafts!
•
Observe the specified tubular covers of the propeller shafts in transport and working position!
(Observe the operating instructions for the propeller shaft!)
•
Observe the admissible angular misalignment and the travel of the propeller shaft when
cornering!
•
Before switching the propeller shaft on, check whether the selected speed of the tractor's p.t.o.
shaft has been adjusted to coincide with the admissible driving speed of the machine!
•
Make sure that people leave the hazardous area of the machine before switching the propeller
shaft on.
•
People are not allowed within the range of the rotating propeller shaft when work with the
propeller shaft is being carried out.
•
Never switch the propeller shaft on with the tractor engine turned off!
•
Always switch the propeller shaft off if the angular misalignments occurring are too large or
when it is not required!
•
Risk of injury due to the flywheel mass of the machine parts continuing to rotate for a short time
after the propeller shaft has been switched off!
Do not approach the machine too closely during that time! Do not carry out any work on the
machine until all machine parts have completely stopped!
•
Secure tractor and machine against accidental starting and rolling before carrying out any
cleaning, lubrication or set-up work on propeller shafts.
•
Place the uncoupled propeller shaft onto the respective holder! Never use the clip chain of the
propeller shaft to hang up the uncoupled propeller shaft.
•
Put the protective cover onto the propeller shaft stub after the propeller shaft has been
uncoupled!
•
In case of the propeller shaft being equipped with an overload or overrunning clutch, this clutch
must always be mounted at the machine.
•
Ensure the correct fitting length and fitting position when coupling the propeller shaft. The
tractor symbol on the protective tube of the propeller shaft indicates the propeller shaft
connection at the tractor.