Strautmann Giga-Vitesse CFS 3602, Руководство по эксплуатации, Страница: 298 / 327

Remedy of malfunctions
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 298
Cutting knives break frequently Defective knife protection
system Check knife protection system
Roller stuck in lever, lever does
not retract Lubricate roller (must turn
easily) or replace lever
Cutting unit extended not far
enough Clean and completely extend
cutting unit
Cutting unit cannot be extended Cutting unit soiled between
cutting knives and conveying
trough
Clean cutting unit
Conveyor duct clogged Clean conveyor duct
Cutting knives bent Align or replace cutting knives
Slip clutch of pick-up responds
frequently Pick-up set too low Readjust setting
Pick-up heavily soiled in its
interior Clean pick-up
Folding drawbar does not move
up Machine overload Adapt charging degree
Hydraulic pressure at tractor too
low Set hydraulic pressure at tractor
to a minimum value of 180 bar
Pick-up, folding drawbar and
tailgate sink during work Hydraulic cylinder leaking Seal hydraulic cylinder
Cutting unit slowly retracting
during work Piston in hydraulic cylinder
leaking Seal piston
Hydraulic cylinder leaking Seal hydraulic cylinder
Hydraulic oil pressure too low Actuate key longer
Machine wobbles heavily during
road travel Tyre pressure too low Adjust tyre pressure according
to table
Machine overload Adapt charging degree
On the hydraulic chassis, one
machine side significantly lowers Machine overload, hydraulic oil
escaping via pressure limiting
valve Adapt charging degree
Plug screw at level block not
tightened Tighten plug screw
Unequal load of axle one and
two Possibly adjust travelling height
Transport floor often switches off
during discharge "Forage wagon full" sensor or
tension spring of beater switch-
off device not set properly Adjust settings
Rotor conveys the material
forward in the integral range Strippers worn or defective. Check strippers, replace them if
necessary.