![background image](http://html1.mh-extra.com/html/omron/cs1w-nc113-rev-02-2008/cs1w-nc113-rev-02-2008_manual_742370309.webp)
11-5
Section
Error Code Lists
299
Group
Operation after
error
Clearing method
Cause
Code
Name
Multiple axis
start
Multiple axis
start
8000
Two or more of the following
commands were executed
simultaneously for the same axis:
START, INDEPENDENT START,
ORIGIN SEARCH, ORIGIN
RETURN, PRESENT POSITION
PRESET, JOG, TEACH,
RELEASE PROHIBIT/ERROR
RESET, ABSOLUTE
MOVEMENT, RELATIVE
MOVEMENT, or INTERRUPT
FEEDING
Correct the ladder
program so that
just one command
is executed for
each axis at one
time and execute
the command
again.
The command will
not be executed.
If the last
command made
before the error
was START,
INDEPENDENT
START, ORIGIN
SEARCH, ORIGIN
RETURN, JOG,
ABSOLUTE
MOVEMENT,
One of the following commands
was executed for a busy axis:
ORIGIN SEARCH, ORIGIN
RETURN, PRESENT POSITION
PRESET, JOG, TEACH,
RELEASE PROHIBIT/ERROR
RESET, ABSOLUTE
MOVEMENT, RELATIVE
MOVEMENT, or INTERRUPT
FEEDING
Correct the ladder
program so that a
command is not
executed for a busy
axis and execute
the command
again.
,
RELATIVE
MOVEMENT, or
INTERRUPT
FEEDING, the axis
with the error will
be decelerated to
a stop.
When interpolation
operation is being
used, all
interpolated axes
A data save operation was
executed while one of the
following commands was in
progress:
START, INDEPENDENT START,
ORIGIN SEARCH, ORIGIN
RETURN, PRESENT POSITION
PRESET, JOG, TEACH,
RELEASE PROHIBIT/ERROR
RESET, ABSOLUTE
MOVEMENT, RELATIVE
MOVEMENT, or INTERRUPT
FEEDING
Correct the ladder
program so that the
data save
operation is
executed while
none of the axes
are busy. Execute
the data save
operation again.
interpolated axes
will be decelerated
to a stop.
If the error is
generated during
data transfer (read
or write) or data
saving, all axes will
be decelerated to
a stop.
Any operating
axes not specified
above will not be
affected
Two or more of the following
commands were executed:
DATA WRITE, DATA READ, or
DATA SAVE
Correct the ladder
program so that
more than one data
transfer (read or
write) or data save
operation is not
executed at the
same time.
Execute the data
transfer or data
save operation
again.
affected.
A START or INDEPENDENT
START command was executed
for a different axis, but a busy axis
was specified in the axis
designation.
Correct the ladder
program so that
busy axes are not
specified for
memory operation
and execute the
command again.
Содержание CS1W-NC113 - REV 02-2008
Страница 1: ...CS1W NC113 213 413 133 233 433 Position Control Units ...
Страница 2: ...iv ...
Страница 4: ...vi ...