Newport MM4006, Руководство пользователя

Страница: 373 / 411

MM4006 A p p e n d i x A — Error Messages
X - Tr a j e c t o r y : first angle definition error.
Y — Tr a j e c t o r y : Line (x, y) Line expected.
Z T r a j e c t o r y : Line (x, y) too big discontinuity.
Trajectory: Line (x. 0) or Line (y, 0) impossible.
\ — Tr a j e c t o r y : Arc expected.
— Tr a j e c t o r y : Arc (r, 0) radius is too small.
A T r a j e c t o r y : Arc (r, 0) radius is too big.
Trajectory: Arc (r, 0) sweep angle is too small.
- Tr a j e c t o r y : Arc (x, y) circle is too small.
a T r a j e c t o r y : Arc (x, y) Circle is impossible.
b — Tr a j e c t o r y : trajectory is empty.
c U n i t not translational or incorrect.
d U n i t not rotationnal or incorrect.
e — Tr a j e c t o r y : Units not translationnal or not identical.
f — s y n c . pulses generation impossible.
g — mechanical familly name incorrect.
h T r a j e c t o r y : execution exceeds physical or logical limits.
Besides the standard screens available on the front panel display, there are
a number of error screens that appear only in special error conditions.
Parameters E r r o r
Fig. A.1— Error screen (English).
n: t o u c o n t i n u e r .
Fig. A.2 — Error screen (French).
The screen in Fig. A.1 (English version) or Fig. A.2 (French version) appears
if the battery-backed non-volatile memory is corrupted. This will result in a
loss of all data in this memory and the controller will request the operator
to perform a complete setup procedure on the front panel.
NOTE
Under certain conditions, you may need to erase the non-volatile memo-
ry and load the default parameters. This is accomplished simultaneously
pressing the minus key " M I " and the period key " M N " on the keypad
during the power-up sequence. This will initiate a setup procedure.
The error message shown in Fig. A.3 appears on power-up if the IEEE488 is
detected to be malfunctioning. Under this condition, only the RS-232 inter-
face can be used.
ED110181En 1020 — 03/03
8.4
C % )
N e w p o r t .