Newport MM4006, Руководство пользователя

Страница: 248 / 411

MM4006
TS R e a d controller status
Usage
■
IMM
■
l'GM
■
MIP
Syntax T S
Parameters N o n e .
Description T h i s command reads the controller status byte.
Returns T S e i (1- to 4-axis controller) or TSc1c2 (5- to 8-axis controller)
Errors
Rel. Commands
c1c2 — Controller status (1 or 2 characters).
Each bit of the status byte represents a particular controller parameter, as
described in the following table:
Bit #
Function for c1
Meaning for
Bit LOW B i t HIGH
0 A x i s #1 motor state
1 A x i s #2 motor state
Axis #3 motor state
Axis #4 motor state
Motor power
Not used
3
4
5
6
7
Not used
IEEE SRQ Interruption Status
(Sent by RQ command)
Stationary
Stationary
Stationary
Stationary
ON
Default
In motion
In motion
In motion
In motion
OFF
Default
NO Y E S
Bit # Function for c2
Meaning for
Bit LOW B i t HIGH
0
1
2
3
4
5
6
Axis #5 motor state S t a t i o n a r y I n motion
Axis #6 motor state S t a t i o n a r y I n motion
Axis #7 motor state S t a t i o n a r y I n motion
Axis #8 motor state S t a t i o n a r y I n motion
Motor power
Not used ON
Default
Not used
IEEE SRQ Interruption Status
(Sent by RQ command)
NO
OFF
Default
YES
NOTE
If bit #7 is high after sending TS command, it toggles low automatically.
The byte returned is in the form of an ASCII character. Converting the ASCII
code to binary will give the status bits values.
NOTE
For a complete ASCII to binary conversion table see Appendix F.
A —
S — Unknown message code.
Communication time-out.
MS — R e a d motor status.
TX — R e a d controller activity.
Example T S I R e a d controller status byte.
TSF I T h e 1- to 4-axis controller returns character F, or ASCII character 70;
converting 70 to binary we get 01000110 which must be interpreted
with the table above.
(%)
iNevvport. 3. 1 5 1
EDH0181En1020 — 03/03