Mitsubishi Electric MDS-E, Инструкция по эксплуатации

Страница: 366 / 554

MDS-E/EH Series Instruction Manual
6 Spindle Adjustment
335 IB-1501229-F
(2) Confirmation in orientation stop at deceleration
≒
0 rotation according to spindle specification
If orientation stop is performed with the load inertia increased due to an excessive workpiece or tool installed to the
spindle, the spindle may start vibrating by trying to reverse after overshooting the stop position and stop after
converging the vibrations (refer to the waveform below).
In this case, the orientation completion time is extended by the time to converge the spindle vibrations. Thus, the
adjustment to suppress the reversing and vibrations at stop is required.
< Adjustment method >
1) Set SP016: Lower the setting value by 5. By lowering, the inclination of the speed becomes gradual. Set the
optimum value while observing the speed waveform so that the speed will not vibrate.
2) Lower the position loop gain.
By lowering the position loop gain, a sway that exceeds the stop position is suppressed.
3) Adjust the speed gain (SP005, SP006).
The converging time becomes shorter if the rigidity during orientation stop is higher. However this affects the
speed stability during constant feed, thus it is required to confirm the speed waveform at the constant speed
and the machining surface during cutting.
Vibration
Motor rotation speed
In-position signal