Mitsubishi Electric MDS-E, Инструкция по эксплуатации

Страница: 71 / 554

MDS-E/EH Series Instruction Manual
1 Installation
40 IB-1501229-F
<Display of spindle PLG diagnosis>
* Used when adjusting a built-in motor.
Installation diagnosis for spindle side PLG encoder
Item Details
Encoder Diagn L Display the motor end PLG diagnosis signal bit 7 to 0. *
Encoder Diagn H Display the motor end PLG diagnosis signal bit F to 8. *
Sub Encoder Diagn L Display the spindle side PLG diagnosis signal bit 7 to 0.
Sub Encoder Diagn H Display the spindle side PLG diagnosis signal bit F to 8.
Information for spindle PLG diagnosis
(For details of each diagnosis signal bit,
refer to the next page.)
When an error is detected with spindle PLG diagnosis
→ "1" is displayed on the corresponding
diagnosis signal bit
1) Power ON
Open loop control enabled
2) Power ON again
5) Open loop control disabled
6) Power OFF
1) Power ON
2) Power ON again
6) Power OFF
4
) Judgment with the diagnosis signal bit
by the PLG diagnosis display
To CN3
Spindle
motor
Spindle
MU1606 (Gear)
TS5690 (Sensor)
Spindle
gear
Motor gear
MU1606 (Gear)
TS5690 (Sensor)
Open loop
3) Rotate the spindle by inputting
100 r/min command
5) Stop the spindle with stop command
2) Disconnect the encoder cable of the motor end encoder
6) Connect the encoder cable of the motor end encoder