Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 393 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
376 IB-1501279-H
Select whether the tool length compensation and wear compensation are enabled during T command exe-
cution.
0 : Tool length compensation enable Wear compensation enable
1 : Tool length compensation enable Wear compensation disable
2 : Tool length compensation disable Wear compensation enable
3 : Tool length compensation disable Wear compensation disable
Select the manual reference position return method for the second return (after the coordinate system is es-
tablished) and later.
The initial reference position return after the power ON is performed with dog-type return, and the coordinate
system will be established.
(This setting is not required when the absolute position detection is used.)
0: High speed return
1: Dog-type
Select whether to correct the error when the servo is OFF.
0: Not correct the error
The command value will not change during servo OFF, and the movement amount during servo OFF will
be handled as droop. When the servo is turned ON the next time, the axis will move to the command
position where it used to be when the servo was turned OFF.
1: Correct the error
The command value and the current position will follow the feedback position. When the servo is turned
ON the next time, the axis will not move.
During servo READY OFF, the operation will be always the same as of "Correct the error". (The current po-
sition will follow the position of the axis.)
Set the axis number of the slave axis in synchronous control.
The axis number is an NC number excluding the spindle and PLC axis.
Two or more slave axis cannot be set for one master axis.
This parameter cannot be set for a slave axis.
When using the multi-part system, the relation of the master axis and slave axis cannot extend over part sys-
tems.
0: No slave axis
1 to 32: 1st axis to 32nd axis
Select whether to display the axis counter or not.
This setting is enabled on the counter display screen (relative position counter, etc.).
0: Display
1: Not display
Select whether to enable or disable axis removal control.
0: Disable
1: Enable
Select the chopping axis.
0: Non-chopping axis
1: Chopping axis
#1062 T_cmp Tool compensation function
#1063 mandog Manual dog-type
(PR) #1064 svof Error correction
(PR) #1068 slavno Slave axis number
#1069 no_dsp Axis with no counter display
#1070 axoff Axis removal
#1072 chop_ax Chopping axis