Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 455 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
438 IB-1501279-H
Set a device of an output remote I/O device to control contactor in safety observation.
When set to "0", contactor shutoff output is disabled.
Thus, "Y0" cannot be used as contactor shutoff output device.
---Setting range---
[M8]
0000 to 02FF (HEX)
[C80]
0000 to 01FF (HEX)
Set a period of time until emergency stop is issued when a contactor does not operate even though contactor
shutoff output 1 is output.
If the vertical axis drop prevention function is used, set a value bigger than the vertical axis drop prevention
time (SV048 EMGrt).
When "0" is set, the contactor operation check will be disabled.
---Setting range---
0 to 30000 (ms)
Select the acceleration/deceleration type of auxiliary axis in PLC axis indexing.
0: Acceleration/deceleration with constant time
1: Acceleration/deceleration with a constant angle of inclination
Select the manual speed command type.
0: Manual speed command
The axis travels at the handle/jog feed rate.
Reverse run is performed for each part system independently of the other ones.
1: Manual speed command 2
In a multi-part system configuration, the axis travels at the handle/jog feed rate multiplied by the ratio of
each part system's program command speeds.
When the block start point is reached in reverse run in any of the part systems, the axes in the other part
systems stop simultaneously.
Select the operation when G31 is commanded in more than one part system.
(Note) When set to "1", the skip coordinate position will always be "0" whether G31 is commanded in a single
part system or in one part system of a multi-part system.
Set to "0" when using G31 command for measurement etc.
0: Carry out G31 command in one part system, while the G31 is kept in an interlocked state in the other
systems.
1: Carry out G31 command simultaneously in more than one part system.
Note that the skip coordinate is not read and so the skip coordinate value will be 0.
Set the maximum override value to be applied to the cutting feed that is in constant inclination acceleration/
deceleration.
When the setting of this parameter is between 0 and 99, the override value is handled as 100% even though
the specified cutting feed override is over 100%.
---Setting range---
0 to 300(%)
Set the remote I/O device to input the observation speed change signal 1 during executing the safety obser-
vation function.
When set to "0", there is no observation speed change signal input.
Therefore "X0" cannot be used as safety observation signal device.
---Setting range---
0000 to 02FF (HEX)
(PR) #1353 MC_ct1 Contactor shutoff output 1 device
(PR) #1357 mchkt1 Contactor operation check allowed time 1
(PR) #1361 aux_acc Auxiliary axis acceleration/deceleration type
#1365 manualFtype Manual speed command type
#1366 skipExTyp Multi-system simultaneous skip command
#1367 G1AccOVRMax Max. override value for cutting feed constant inclination
acc./dec.
(PR) #1369 S_Sig1 Safety observation signal device 1