Danfoss does not take responsibility for incorrect installation or
any frequency interference.
Chance of unintended machine movement on start up.
Ensure the machine is stopped for the entire duration of the
assembly process.
Keep the work area free and wear protective clothing.
To guarantee the specified autonomy or the product, it is
necessary to use AAA LR03 (x3) Alkaline batteries with nominal
capacities between 900 and 1155 mAh. It is highly
recommended to use brands with PLUS type or similar with
nominal capacities close to 1155 mAh. Rechargeable batteries
are not recommended because of their lower nominal capacity.
1. Connect the power supply and the outputs according to
the connection block diagram provided with the system.
The configuration of the radio node can last up to 1 minute.
2. Insert the EEPROM and the batteries.
3. Push and pull out the STOP button.
The status LED will pulse blue until the stand by mode is
reach, then it will turn into a continuous blue.
[1]
[2]
[3]
I
II
4. Press the start button.
The status LED will pulse green until the transmitter is
linked with the receiver. The LED will turn into a continuous
green when the receiver confirms the link.
RX
I
II
RX
I
II
The system is now fully operational.
Installation Guide
Remote Control
IKORE + R11
©
Danfoss | December 2018
AN290872682441en-000101 | 1
