Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 400 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
383 IB-1501279-H
Select the number of digits of the tool length compensation No. in the T command.
0: Lower 3 digits in T code serve as a tool length and wear offset Nos.; the remaining upper digits as a tool
No.
1: Lower 3 digits in T code serve as a tool wear offset No.; the remaining upper digits as a tool No. and tool
length offset No.
Select how to handle the tool compensation vector when resetting the system.
0: Clear the tool length and wear compensation vectors when resetting
1: Hold the tool length and wear compensation vectors when resetting
When the values are cleared, the compensation will not be applied. So the axis will be shifted by the com-
pensation amount in the next compensation operation.
When the values are kept, the compensation will be applied, so the axis will shift the differential amount of
the compensation amount in the next compensation operation.
Select when to perform tool length compensation and wear compensation.
0: Compensate when T command is executed.
1: Superimpose and compensate with the travel command in the block where the T command is located.
If there is no travel command in the same block, compensation will be executed after the travel command
is superimposed in the next travel command block.
2: Compensate the wear amount when the T command is executed. Superimpose and compensate the
tool length compensation amount with the travel command in the same block. If there is no travel com-
mand in the same block, compensation will be executed after the travel command is superimposed in
the next travel command block.
Select the type of travel command when "#1100 Tmove" is set to "1" or "2".
0: Compensate regardless of the travel command type
1: Compensate only at the travel command in the absolute command
Select whether to use the tool life management.
0: Not use
1: Use
Select how to handle the tool command in the program when "#1103 T_Life" is set to "1".
0: Handle the command as group No.
1: Handle the command as tool No.
(Note) In the case of the tool life management III, the program tool command will be handled as the tool No.
regardless of the setting.
Select the tool selection method when "#1103 T_Life" is set to "1".
0: Select in order of registered No. from the tools used in the same group.
1: Select the tool with the longest remaining life from the tools used or unused in the same group.
Select the input method when address N is omitted in inputting the data (G10 L3 command) for tool life man-
agement function II.
0: Time specified input
1: Number of times specified input
#1098 Tlno. Tool length offset number
#1099 Treset Cancel tool compensation amount
#1100 Tmove Tool compensation
#1101 Tabsmv Tool compensation method
#1103 T_Life Validate life management
#1104 T_Com2 Tool command method 2
#1105 T_Sel2 Tool selection method 2
#1106 Tcount Life management (for L system only)