Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 489 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
472 IB-1501279-H
Not used. Set to "0".
Set a feed forward gain for pre-interpolation acceleration/deceleration.
The larger the set value, the smaller the theoretical control error will be. However, if a machine vibration oc-
curs, set the smaller value.
---Setting range---
0 to 200 (%)
Set up the backlash compensation amount when the direction is reversed with the movement command in
rapid traverse feed mode or in manual mode (except for handle feed mode) .
---Setting range---
-9999999 to 9999999
Set up the backlash compensation amount when the direction is reversed with the movement command in
cutting mode.
G1 backlash is enabled in handle feed mode.
---Setting range---
-9999999 to 9999999
Set a soft limit area with reference to the zero point of the basic machine coordinate. Set the coordinate in
the negative direction for the movable area of stored stroke limit 1. The coordinate in the positive direction is
set in "#2014 OT+".
To narrow the available range in actual use, use the parameters "#8204 OT-" and "#8205 OT+".
When the same value (other than "0") is set in this parameter and "#2014 OT+", this function will be disabled.
---Setting range---
-99999.999 to 99999.999 (mm)
#2009 G1t2
#2010 fwd_g Feed forward gain
#2011 G0back G0 backlash
#2012 G1back G1 backlash
#2013 OT - Soft limit I -
OT-(Z)
OT-(X)
OT+ (Z)
OT+(X)
Basic machine coordinate
Movable area