Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 383 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
366 IB-1501279-H
bit0: Skip speed spec: Cutting feed override ON
Select whether to enable cutting feed override for a skip command.
0: Disable
1: Enable
bit1: Skip speed spec: Dry run ON
Select whether to enable dry run for a skip command.
0: Disable
1: Enable
bit2: Skip speed spec: Feed rate selection
Select the feed rate for a skip command.
0: A feed rate given to address F of the G31 block. If the G31 block has no address F, the value specified
by "#1174 skip_F" is applied. In either case the F modal status is unchanged.
1: A feed rate programmed as an F modal value. F modal status is updated by the address F given to the
G31 block.
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
Set M codes to which pre-read will not be applied.
---Setting range---
0 to 99999999
#12022 skipF_spec
(PR) #12023 Mblkstp1 Pre-read prohibited M code 1
(PR) #12024 Mblkstp2 Pre-read prohibited M code 2
(PR) #12025 Mblkstp3 Pre-read prohibited M code 3
(PR) #12026 Mblkstp4 Pre-read prohibited M code 4
(PR) #12027 Mblkstp5 Pre-read prohibited M code 5
(PR) #12028 Mblkstp6 Pre-read prohibited M code 6
(PR) #12029 Mblkstp7 Pre-read prohibited M code 7
(PR) #12030 Mblkstp8 Pre-read prohibited M code 8