Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 377 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
360 IB-1501279-H
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where the mixed
control (cross axis control) request signal is input, or the name of the axis to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
Set the lower limit of the override for involute interpolation override.
---Setting range---
0 to 100 (%)
Set the maximum acceleration (time constant) for the acceleration clamping during involute interpolation.
---Setting range---
0 to 32767 (ms)
Set the minimum feedrate for the acceleration clamping during involute interpolation.
---Setting range---
0 to 999999 (mm/min)
The workpiece coordinate display during 3D coordinate conversion is switched to the workpiece coordinate
system or G68 program coordinate system.
0: Workpiece coordinate system
1: G68 program coordinate system
(Note) The special display unit's absolute coordinates also follow this parameter setting.
#1541 crsax[5]
#1542 crsax[6]
#1543 crsax[7]
#1544 crsax[8]
#1558 IvOMin Involute interpolation override lower limit value
#1559 IvAMax Involute interpolation allowable acceleration speed
#1560 IvFMin Involute interpolation minimum feedrate
#1561 3Dcdc Switch workpiece coordinate display during 3D coordi-
nate conversion