Mitsubishi Electric C80 Series, Руководство пользователя

Страница: 223 / 748

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
206 IB-1501279-H
Compensation distance tolerance
Specify the upper limit of the distance between the command position and compensation position when the
smooth fairing function is ON.
If you specify a negative value, operation is conducted with no tolerance limit.
If "0" is set, the tolerance will be 0.005 (mm).
---Setting range---
-1.000 to 100.000 (mm)
Set the length from the center of the normal line control axis to the tool tip. This is used to calculate the turning
speed at the block joint.
This is enabled during the normal line control type II.
---Setting range---
0.000 to 99999.999 (mm)
Set the radius of the arc to be automatically inserted into the corner during normal line control.
This is enabled during the normal line control type I.
---Setting range---
0.000 to 99999.999 (mm)
Set the length from the tool holder to the tool tip.
---Setting range---
0.000 to 99999.999 (mm)
Set the command increment scale.
The scale will be "1" when "0" is set.
---Setting range---
0 to 10000 (fold)
0: One fold
Select whether to enable the variable speed thread cutting function.
0: Disable
1: Enable
Set the tolerable error range to avoid a program error (a shape change at pocket machining) against minute
inversion when the finished shape's Z axis (or X axis at G72 command) does not move monotonously.
---Setting range---
0.000 to 0.010 (mm)
Set the minimum cutting amount for compound type thread cutting cycle (G76).
The value set in this parameter will be applied when the cutting amount in compound thread cutting cycle
(G76) without Q command is smaller than that in this parameter.
This parameter is valid only when "#1222 aux06/bit4" is set to "1".
---Setting range---
0.000 to 99999.999 (mm)
#8039 Comp. range limit
#8041 C-rot.R
#8042 C-ins.R
#8043 Tool HDL FD OFS
#8044 UNIT*10
#8045 Varying spd thread
#8060 G71 ERR
#8061 G76 THICK