Leibinger JET3, Руководство по эксплуатации

Страница: 371 / 406

Group 10 Setting-up/Maintenance Page 369
JET3 Series Release 2.02
Example: Solvent refill bottle in screwed on position
Screw the still sealed re-fill bottle on the corresponding reservoir tank. The seal of the
bottle will be breached while the bottle is screwed on the tank, the closing valve of the
tank will open automatically and the reservoir tank is filled up. Do not remove the re-
filling bottle until it is complete empty. When the printer gives you a refilling message the
reservoir tank is empty so that a complete bottle can be filled in.
Twist off the empty re-filling bottle. The closing valve of the corresponding reservoir tank
will be closed automatically. Finally screw up the cap of the reservoir tank as well as the
empty refill bottle carefully.
Attention
Important hints!
Do not dispose
the empty bottles before you have activated the ink or the
solvent!
After filling the reservoir tanks as well as the empty refill bottles, they have
to be closed carefully again.
You have absolutely to fill in the complete bottle because the bottle will be
devaluated and can be not activated anymore!
11. When you refilled the reservoir tanks without the activation of an ink or a solvent after
a little while one or both of the following message will be displayed. One is requested to
carry out the TAG-activation of the refilled ink or solvent afterwards.
12. Carry out the TAG activation as described in points 3. to 9 .